DiveSigns.com: Be seen when it counts! ::: Hard wearing high reflective vinyl stickers for diving

Search:



Languages:
English


Currencies:





Alert Marker Identification Stickers


£5.00

Click image to zoom in




Surface Marker Buoys that are factory fitted with a strip of SOLAS reflective tape can now be personalised with Dive Signs Alert Marker Identification Stickers.

Dive Signs Alert Marker Identification Stickers are sold in pairs so both sides of your DSMB can be labled. Each sticker can have your choice of text. For example, one side could display a message 'IF FOUND CALL -' and a contact number. The other sticker could show an email address, website URL, dive centre name, dive team/club name, owner's name etc.

These very smart black vinyl stickers are simple to fit onto the factory fitted SOLAS tape and require no extra gluing. 

Due to the small text size of Alert Marker Identification Stickers they are not intended to be used for in-water diver identification by a dive boat crew or surface cover. For in-water diver identification use Dive Signs SOLAS stickers.

To ensure your stickers fit in the space you have available please enter the maximum sticker length required (in mm) in the Sticker Length box below. If left blank, the stickers will be the standard length for the text ordered. Please note that Sticker Length will only be altered to a smaller size than standard

Fitting Guide:

First the factory fitted SOLAS tape must be cleaned with warm soapy water to remove any grease or salt deposits then completely dried. No washing is required on a new DSMB.

Completely deflate the DSMB and lay it on a flat surface.

Carefully remove the sticker backing paper so that the black vinyl text is left on the application tape. While keeping tension on the application tape, position the sticker on the SOLAS tape. 

Because vinyl is pressure-sensitive, a squeegee or old credit card should be used for installation.  The purpose of using a squeegee is to remove the excess air from behind the vinyl.  You should start the squeegee from the middle and use a top to bottom motion until the sticker is flat on the SOLAS tape, then a firm left to right motion can be used.  Allow the vinyl to set for 5 to 15 minutes.

Peel up one corner of the application tape then slowly peel it off, following the line of the sticker. The black vinyl text will then be revealed on the SOLAS tape strip. 




Add to Cart:

Please Choose:









This product was added to our catalog on Monday 09 November, 2009.



Customers who bought this product also purchased...



Gas Analysis Stickers - 6 Sticker Set


Gas Analysis Stickers - 6 Sticker Set






Alien - Diver Identification Stickers (30mm - 45mm)


Alien - Diver Identification Stickers (30mm - 45mm)





Gas Analysis Stickers


Gas Analysis Stickers





Wheelie Bin Stickers - Set of 6


Wheelie Bin Stickers - Set of 6






Alien - MOD Stickers


Alien - MOD Stickers





Alien - Diver Identification Stickers (60mm - 75mm)


Alien - Diver Identification Stickers (60mm - 75mm)






Specials   |   Advanced Search   |   Contact Us   |   My Account   |   Log In
Copyright © 2017 DiveSigns.com. Site created and maintained by Evilprofessor Designs. Privacy Notice

Nochex - Online Payment Services